Trane VUVE Vertical Classroom Manual de instalación descargar pdf (Pagina 19)

UV-SVN03F-EN 19

Pre-Installation

Jobsite Inspection

Always perform the following checks before accepting a

unit:

1. Verify that the nameplate data matches the data on the

sales order and bill of lading (including electrical data).

2. Verify that the power supply complies with the unit

nameplate specifications.

3. Visually inspect the exterior

of the unit, for signs of

shipping damage. Do not sign the bill of lading

accepting the unit(s) until inspection has been

completed. Check for damage promptly after the

unit(s) are unloaded. Once the bill of lading is signed at

the jobsite, the unit(s) are now the property of the

SOLD TO party and future freight claims MAY NOT be

accepted by the freight company.

Jobsite Storage

This unit is intended for indoor use only. To protect the unit

from damage due to the elements, and to prevent possible

IAQ contaminant sources from growing.

1. Place the unit(s) on a dry surface or raise above the

ground to assure adequate air circulation beneath the

unit.

2. Cover the unit(s) with a water proof tarp to protect

them

from the elements.

3. Make provisions for continuous venting of the covered

units to prevent moisture from standing on the unit(s)

surfaces.

4. Do not stack units.

NOTICE:

Microbial Growth!

Wet interior unit insulation can become an

amplification site for microbial growth (mold), which

may cause odors and damage to the equipment and

building materials. If there is evidence of microbial

growth on the interior insulation, the insulation should

be removed and replaced prior to operating the system.

UV-SVN03_.book Page 19 Thursday, January 24, 2013 5:27 PM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 110 111

Sin comentarios

Trane VUVE Vertical Classroom Manual de instalación Pagina 19