Trane Modular 20 to 35 Tons Manual de instalación descargar pdf (Pagina 8)

8 CXRC-SVX01F-EN

Pre-Installation

Receiving

Receiving Checklist

Complete following checklist immediately after receiving

shipment to detect any shipping damage.

• Inspect individual cartons before accepting. Check for

rattles, bent carton corners, or other visible indications

of shipping damage.

• If a unit appears damaged, inspect it immediately

before accepting the shipment. Make specific

notations concerning the damage on the freight bill.

Do not refuse delivery.

• Inspect the unit for concealed damage before it is

stored and as soon as possible after delivery. Report

concealed damage to the freight line within the allotted

time after delivery. Check with the carrier for their

allotted time to submit a claim.

• Do not move damaged material from the receiving

location. It is the receiver’s responsibility to provide

reasonable evidence that concealed damage did not

occur after delivery.

• Do not continue unpacking the shipment if it appears

damaged. Retain all internal packing, cartons, and

crate.Take photos of damaged material if possible.

• Notify the carrier’s terminal of the damage

immediately by phone and mail. Request an

immediate joint inspection of the damage by the

carrier and consignee.

• Notify yourTrane representative of the damage and

arrange for repair. Have the carrier inspect the damage

before making any repairs to the unit.

Contractor Installation

Responsibilities

Complete the following checklist before beginning final

unit installation.

• Verify the unit size and tagging with the unit

nameplate.

• Make certain the floor or foundation is level, solid, and

sufficient to support the unit and accessory weights.

Level or repair the floor before positioning the unit if

necessary.

Note: For a detailed discussion of base and

foundation construction seeTheTrane

Reciprocating Refrigeration Manual. This

manual is available through the localTrane

sales office.

Note: On rooftop applications be certain that the roof

structure has sufficient strength to support the

unit operating weight. See Table 4, p. 10 for unit

shipping weight and operating weight, and

Table 5, p. 14 for point loading information.

• Allow minimum recommended clearances for routine

maintenance and service. Allow space at end of the

unit for shaft removal and servicing. Refer to unit

submittals for dimensions. See also

“Service

Clearances,” p. 10.

• Allow three fan diameters above the unit for the

discharge ductwork. Return air enters the rear of the

unit and conditioned supply air discharges through the

top.

• Electrical connection knockouts are on the top, left side

of the unit.

• Allow adequate space for piping access and panel

removal. Condenser water piping, refrigerant piping,

and condensate drain connections are on the lower left

end panel.

Note: Unit height and connection locations will change if

using vibration isolators.The unit height may

increase up to 5 7/8” with spring type isolators.

• Electrical supply power must meet specific balance

and voltage requirements as described in section

“Installation - Electrical,” p. 17.

• Air-cooled units only:The installer is responsible for

providing and installing the remote air-cooled

condenser and refrigerant piping, including filter

driers.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comentarios a estos manuales

Sin comentarios

Trane Modular 20 to 35 Tons Manual de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para No Trane Modular 20 to 35 Tons