
VRF-SVX28A-EN 23
Configuration
Mode 2: Option Setting
When digit 2 is set to a value of “2,” the options shown in Table 1 can be set to the values in the
right column.
Table 1. Option setting mode: Digit 2 = 2
Display
screen
(mode and
On/Off)
Digit
Option description Set digit to...
N/A 1 Factory set to 0 Cannot be changed. Not seen in configuration mode.
2 Option setting mode 2
3 Robot cleaning
0: Disabled
1: Enabled
4 Remote sensor
0: Disabled
1: Enabled
5 Central control
0: Disabled
1: Enabled
6RPM up
0: Disabled
1: Enabled
N/A 7 Factory set to 1 Cannot be changed. Not seen in configuration mode.
8Drain pump
0: Disabled
1: Enabled (no delay)
2: Enabled (3-min delay)
(a)
9Hot water heater
0: Disabled
1: Enabled
10 Electronic heater
0: Disabled
1: Enabled
11
EEV position when heating is
satisfied
0: EEV step is minimum (default)
1: Reduced noise setting
12
Master/Slave unit
designation
(b)
0: Slave
1: Master
N/A 13 Factory set to 2 Cannot be changed. Not seen in configuration mode.
Comentarios a estos manuales