Trane Performance Air Handlers Manual de instalación descargar pdf (Pagina 25)

CAH-SVX01B-EN 25

Installation - Mechanical

TCP Wall Section Assembly

Exterior Wall Assembly (Typical)

1. See Figure 12. Ensure shipping split sections are aligned and pulled together properly.

2. Apply a bead of caulk to full height of wall joint.

3. Apply 3-inch x 1/8-inch adhesive-backed foam gasket to inner joining strip.

4. Install inner joining strip using #14 x 1.5-inch gasketed tec screws.

5. Fit the pre-cut hub cap over the joining strip the vertical height of the wall flush with the roof

and secure it to the wall with # 8 sheet metal screws. Fill the top and bottom openings with caulk

as a moisture seal. Screw holes can be pre-drilled with a #29 bit.

Interior Wall and Roof Joint Assembly (Typical)

1. See Figure 12. Ensure shipping split sections are aligned and pulled together properly.

2. Pre-drill interior joining strip screw holes using #29 drill bit.

3. Apply a bead of caulk the full height of interior wall joint.

4. Install joining strips using #10 sheet metal screws.

Figure 12. Wall section assembly

Add caulking after

installing J strip

#8 x 1-in. Phillips zip screw

2 3/4-in. wide joining strip

Wall split

4-in. x 1/4-in. gasket

Add caulking before

installing J strip

Wall panel section split

2 3/4-in. wide joining strip

Trim cap

#10 x 1-in. self tapping screw

3-in. x 1/8-in. neoprene gasket is

applied to metal joining strip.

Apply gasket to metal strip

before installation.

#8 x 1-in. Phillips zip screw

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 99 100

Sin comentarios

Trane Performance Air Handlers Manual de instalación Pagina 25