Trane Performance Air Handlers Manual de instalación descargar pdf (Pagina 31)

CAH-SVX01B-EN 31

Installation - Mechanical

TCP Stacked Unit Assembly

1. Install and assemble all lower sections as described in typical assembly.

2. Lift first piece of upper section into place assuring proper alignment with lower unit.

3. Install 10 gauge 12-inch angle clips as shown in Figure 18 and secure with grade 5 self-tapping

screws placed 4-inches on center.

4. Lift next upper piece into place and secure shipping split with appropriate hardware then

anchor to lower section as described above.

5. Continue until all sections are installed and anchored properly.

6. Install the 18-gauge cover trim cap using #10 self drilling screws. See Figure 18.

Figure 18. Stacked unit trim assembly

Cap

18 ga. steel

.050 if aluminum

Upper unit

Lower unit

Roof trim cap

14 ga. minimum

.125 if aluminum

12-in. clip every 8 ft.

and at all corners use

grade 5 self-tapping

screws 4-in. ctc

10 ga. steel

.125 if aluminum

10 1/2

7 1/2

4 1/2

1 1/2

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 99 100

Sin comentarios

Trane Performance Air Handlers Manual de instalación Pagina 31