Trane Performance Air Handlers Manual de instalación descargar pdf (Pagina 28)

28 CAH-SVX01B-EN

Installation - Mechanical

TCP Indoor Roof Section Assembly (Typical)

1. Ensure shipping split sections are aligned and pulled together properly.

2. Apply a bead of caulk to full height of wall joint.

3. Apply 3-inch x 1/8-inch adhesive-backed foam gasket to inner joining strip.

4. Install inner joining strip using #14 x 1.5-inch gasketed tec screws.

5. Fit the pre-cut hub cap over the joining strip the vertical height of the wall flush with the roof

and secure it to the wall with #8 sheet metal screws.

6. Fill the top and bottom openings with caulk as a moisture seal. Screw holes can be pre-drilled

with a #29 bit.

7. Apply a bead of caulk over top corner of cap seam.

8. Using #10 sheet metal screws, attach corner seam trip cap as shown in Figure 15.

Figure 15. TCP indoor wall and roof assembly - trim cap

18 ga. strip

18 ga. trim cap

No greater than 6 inch spacing

on all fasteners

18 ga. trim cap

Gasket

#10 SMS

“Zip” screw

18 ga. strip

18 ga. trim cap

18 ga. strip

Interior

of unit

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 99 100

Sin comentarios

Trane Performance Air Handlers Manual de instalación Pagina 28