Trane Performance Air Handlers Manual de instalación descargar pdf (Pagina 40)

40 CAH-SVX01B-EN

Installation - Mechanical

TCC Stacking Procedure

1. After bottom section of stacked arrangement is in place, ensure top is clean and free of debris.

2. Apply two layers of 0.188-inch x 2-inch gasketing around perimeter of top section layout. See

Figure 34.

3. Apply two layers of 1-inch x 2-inch tape around perimeter of openings in lower unit roof. See

Figure 34 and Figure 35.

4. Lift upper section into place carefully aligning into proper position (see Figure 35).

5. Install 0.250-14 x 0.750 self drilling screws in each hole around upper unit base perimeter.

6. Install flashing at base of top section (see Figure 35 Detail A).

Figure 34. Upper base connection to lower unit gasket.

Apply two layers of 1-inch x 2-inch

gasketing around all openings in

the lower unit roof.

Upper unit

Lower unit

Factory installed

engagement plate

Apply .188-inch x 2-inch

gasketing around lower

unit perimeter

.250 - 14 x .75 leached self-driller

screws in every hole, around upper

unit base perimeter.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

Sin comentarios

Trane Performance Air Handlers Manual de instalación Pagina 40